TOP MESSAGE FROM CEO MANAGEMENT POLICY COMPANY PROFILE

yoshimurakasei

Bei-cook

 We held cooking contest named as “Bei-lympic” which was our in-house cooking competition by using BAKEQ container as a cooking device.
Successfully received 116 applicants and final results was announced on Facebook.


We developed dual fitting lid (fit as is before cooking and fit shrinked container after cooking) to some BAKEQ containers.
Therefore, you may prepare foods prior to the cooking in the BAKEQ container with lid at one place and later you may cook the prepared foods at the other place for sale with the same lid.

ベイクック


PP CONTAINERS

PP CONTAINERS
With high oxgen barrier
With high-heat-resistantce for retort
With various types of easy to open system.
Withstand both freezing and microwave oven heating temperature

BAKEQ(CPET) CONTAINERS

BAKEQ(CPET) CONTAINERS
Our hest-set technology for PET to make crystalline CPET container
With high-heat-resistance at 220℃
With high gas barrier

PBT/PET CONTAINER

PBT/PET CONTAINER
With transparent appearance
With high-heat-resistance for retort
With good gas barrier

Bottom up container

Bottom up container
Thermoformed bottom-up container ,melted to form bottom edge tight, have therefore stand for high temperature sterilization such as retort.without bursting the bottom edge.

YY-Lid

YY-Lid(We named patented thermoformed curled- edge-structure lid as YY-Lid)
Thermoformed curled-edge-structure lid (container) make consumer safe to avoid cutting fingers due to avoid direct touch to the edge of the lid or containers.

Multi-punching-cut container by 3(three) consecutive puncher system

Multi-punching-cut container by 3(three) consecutive puncher system
Typical example is to make 4 portion container separated by dot-cutting line with finger-holding-hole in the center of the container made through 3 consecutive trimming system.

Mirror touch flat surface lid or container

Mirror touch flat surface lid or container
Thanks to our no air-trapped forming during thermoforming process, mirror-touch-flat-surface is made to form lid or container.

Three dimensional trimmed container & multi-hole cutting container

Three dimensional trimmed container & multi-hole cutting container
On your request, we would like to challenge to accept any kind of difficult task or request such as above.

Majic Top Container

Majic Top Container (licensed by Idemitsu Unitech)
Tight seal but easy to open paradox” is a real for“Majiic Top” container under license from Idemitsu Unitech.

Continuous challenge for transparent but highly functional PP container

Continuous challenge for transparent but highly functional PP container
Continuous challenge to make transparent PP container to offer excellent gas barrier properties as well as high heat resistance such as 115℃
>詳しくはこちら


Continuous challenge for high heat resistant containers

Continuous challenge for high heat resistant containers
With our “BAKEQ” container you may cook foods on this container and put the lid on for sale.
Your customer may enjoy ready-to-eat meal easily after microwave-oven warming.

>詳しくはこちら


Continuous challenge for seeking additional functions

Continuous challenge for seeking additional functions
Such as “Majic Top” container for tight seal for retort with easy-to-open function, container with steam vent function and container for gas exchange package
>詳しくはこちら


Continuous challenge to meet customer’s request for unique-design container

Continuous challenge to meet customer’s request for unique-design container
Such as bottom up container, three dimensional trimmed container, dot cutting line container
Multi hole cutting container, and curled edge lid etc. etc.

>詳しくはこちら


Continuous challenge for environment and safety care packaging

Continuous challenge for environment and safety care packaging
Such as reducing plastic materials by YY-Lid, because of thin gauge material may use due to avoid direct impact to the edge of the container, which is the main cause of breaking lid or container.
>詳しくはこちら

yoshimura_line_transparent.png